The WTN-DB is used with ALGE-TIMING display boards to receive data by communicating with one or more WTN devices using the 2.4 GHz band. It can also be used as hub to pass on data or timing impulses within the network.
frequency:
2.4 GHz band (15 adjustable teams)
transmitting power:
10 mW and/or 10 to 100 mW (adjustable)
range:
ca. 350 m at unobstructed sight
display board interface:
RS232 interface - 2400 to 19200 Baud
power supply:
from the display board or from external battery with cable 292-05
casing:
water-proof plastic casing with clamping holding
With the WTN-WS device you can connect the WS2 and a display board to the Timy3.
The ALGE-TIMING anemometer WS2 works with calorimetric mass flow sensor. This allows a fast and precise air speed measurement and shows an exceptional dynamic. The optimal design of the sensor and the rapid reaction time for a measurement prevent wind changes between the measurements and permit measurements below 1 m/s. The WS2 does not need any...
The WTN-DB is used with ALGE-TIMING display boards to receive data by communicating with one or more WTN devices using the 2.4 GHz band. It can also be used as hub to pass on data or timing impulses within the network.
